Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 51 of 509
Mod. 0808 2011-07 Rev.2
Return To On Line Mode - O
O - Return To On Line Mode
Execution command is used to return to on-line mode from command mode. If
there's no active connection it returns NO CARRIER.
Note: After issuing this command, if the device is in conversation, to send other
commands to the device you must return to command mode by issuing the escape
sequence (see register S2).
The escape sequence causes a closure of the link.
4.1.3.3. Modulation Control
Line Quality And Auto Retrain - %E
%E - Line Quality Monitor And Auto Retrain Or Fallback/Fallforward
Execution command has no effect and is included only for backward compatibility
with landline modems.
To Next Page
Loading...
Need help?
General
