Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 58 of 509
Mod. 0808 2011-07 Rev.2
Select TE Character Set - +CSCS
+CSCS - Select TE Character Set
[<chset>]
Set command sets the current character set used by the device.
Parameter:
<chset> - character set
“GSM” - GSM default alphabet (3GPP TS 23.038)
“IRA” - international reference alphabet (ITU-T T.50)
”8859-1” - ISO 8859 Latin 1 character set
”PCCP437” - PC character set Code Page 437
”UCS2” - 16-bit universal multiple-octet coded character set (ISO/IEC10646)
Read command returns the current value of the active character set.
Test command returns the supported values for parameter <chset>.
International Mobile Subscriber Identity (IMSI) - +CIMI
+CIMI - Request International Mobile Subscriber Identify (IMSI)
Execution command returns the value of the Internal Mobile Subscriber Identity
stored in the SIM without command echo.
Note: a SIM card must be present in the SIM card housing, otherwise the command
Test command returns OK result code.
To Next Page
Loading...
Need help?
General
