Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 153 of 509
Mod. 0808 2011-07 Rev.2
4.1.5. 3GPP TS 27.005 AT Commands for SMS and CBS
4.1.5.1. General Configuration
Select Message Service - +CSMS
+CSMS - Select Message Service
<service>
Set command selects messaging service <service>. It returns the types of messages
supported by the ME:
Parameter:
<service>
0 – 3GPP TS 23.040 and 3GPP TS 23.041. The syntax of SMS AT commands is
compatible with 3GPP TS 27.005 (factory default)
1 – 3GPP TS 23.040 and 3GPP TS 23.041. The syntax of SMS AT commands is
compatible with 3GPP TS 27.005. The requirement of <service> setting 1 is
mentioned under corresponding command descriptions
Set command returns the types of messages supported by the ME:
+CSMS: <mt>,<mo>,<bm>
where:
<mt> - mobile terminated messages support
0 - type not supported
1 - type supported
<mo> - mobile originated messages support
0 - type not supported
1 - type supported
<bm> - broadcast type messages support
0 - type not supported
Read command reports current service setting along with supported message types
in the format:
+CSMS: <service>,<mt>,<mo>,<bm>
where:
<service> - messaging service (see above)
<mt> - mobile terminated messages support (see above)
<mo> - mobile originated messages support (see above)
<bm> - broadcast type messages support (see above)
Test command reports the supported value of the parameter <service>.
3GPP TS 27.005; 3GPP TS 23.040; 3GPP TS 23.041
To Next Page
Loading...
Need help?
General
