Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 395 of 509
Mod. 0808 2011-07 Rev.2
#SKTSAV - Socket Parameters Save
OK
socket parameters have been saved in NVM
If some parameters have not been previously specified then a default value will be
stored.
Socket Parameters Reset - #SKTRST
#SKTRST - Socket Parameters Reset
Execution command resets the socket parameters to the “factory default”
configuration and stores them in the NVM of the device.
The socket parameters to reset are:
- User ID
- Password
- Packet Size
- Socket Inactivity Time-Out
- Data Sending Time-Out
- Socket Type
- Remote Port
- Remote Address
- TCP Connection Time-Out
Test command returns the OK result code.
OK
socket parameters have been reset
GPRS Context Activation - #GPRS
#GPRS - GPRS Context Activation
[<mode>]
Execution command deactivates/activates the PDP context #1, eventually
proceeding with the authentication with the parameters given with #PASSW and
#USERID.
Parameter:
<mode> - PDP context activation mode
0 - PDP context #1 deactivation request
1 - PDP context #1 activation request
In the case that the PDP context #1 has been activated, the result code OK is
preceded by the intermediate result code:
+IP: <ip_address_obtained>
reporting the local IP address obtained from the network.
To Next Page
Loading...
Need help?
General
