To Next Page

To Previous Page

Telit LE910 V2 Series AT Commands

80446ST10707A Rev. 0– 2015-11-03

Mod. 0808 2011-07 Rev.2

#REBOOT - Reboot

SELINT 2

Note: if AT#REBOOT follows an AT command that stores some parameters in

NVM, it is recommended to insert a delay of at least 5 seconds before to issue

AT#REBOOT, to permit the complete NVM storing

Note: AT#REBOOT is an obsolete AT command; please refer to AT#ENHRST to

perform a module reboot

AT#REBOOT=?

Test command returns OK result code.

Example

AT#REBOOT

… Module Reboots …

4.1.6.2. Easy Scan® Extension AT Commands

NOTE:

it is

mandatory

to issue all the Easy Scan® Extension AT commands with the

module configured in

+COPS: 2

mode, that is in detached mode, to avoid any

potential conflict with normal module operations, such as “incoming call”,

“periodic location update, “periodic routing area update” and so on.

Any possible trigger of competing network activity must be deactivated. In this

logic SIM toolkit must be deactivated.

Network Survey - #CSURV

#CSURV - Network Survey

SELINT 2

AT#CSURV[=

[<s>,<e>]]

Execution command allows to perform a quick survey through band

channels, starting from channel

<s>

to channel

<e>

. Issuing

AT#CSURV<CR>

, a full band scan is performed.

Parameters:

<s>

- starting channel

<e>

- ending channel

After issuing the command the device responds with the string:

Brand	Telit Wireless Solutions
Model	LE910
Category	Control Unit
Language	English

Telit Wireless Solutions LE910 User Manual

Table of Contents

Questions and Answers:

Telit Wireless Solutions LE910 Specifications

Related product manuals