EasyManuals Logo

Telit Wireless Solutions LE910 User Manual

Telit Wireless Solutions LE910
509 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #352 background imageLoading...
Page #352 background image
Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 352 of 509
Mod. 0808 2011-07 Rev.2
IP Easy Authentication Type - #SGACTAUTH
#SGACTAUTH Easy GRPS Authentication Type
SELINT 2
AT#SGACTAUTH=
<type>
Set command sets the authentication type for IP Easy
This command has effect on the authentication mode used on AT#SGACT or
AT#GPRS commands.
Parameter
<type>
0 - no authentication
1 - PAP authentication (factory default)
2 - CHAP authentication
Note: the parameter is not saved in NWM
AT#SGACTAUTH?
Read command reports the current IP Easy authentication type, in the format:
#SGACTAUTH: <type>
AT#SGACTAUTH
=?
Test command returns the range of supported values for parameter <type>.
Context activation and configuration - #SGACTCFG
#SGACTCFG - Context Activation and Configuration
SELINT 2
AT#SGACTCFG=
<cid>,
<retry>,
[,<delay >
[,<urcmode >]]
Execution command is used to enable or disable the automatic
activation/reactivation of the context for the specified PDP context, to set the
maximum number of attempts and to set the delay between an attempt and the
next one. The context is activated automatically after every GPRS Attach or
after a NW PDP CONTEXT deactivation if at least one IPEasy socket is
configured to this context (see AT#SCFG).
Parameters:
<cid> - PDP context identifier (see +CGDCONT command)
1..5 - numeric parameter which specifies a particular PDP context definition
<retry> - numeric parameter which specifies the maximum number of context
activation attempts in case of activation failure. The value belongs to the
following range: 0 - 15
0 - disable the automatic activation/reactivation of the context (default)
<delay> - numeric parameter which specifies the delay in seconds between an
attempt and the next one. The value belongs to the following range: 180 -
3600
< urcmode > - URC presentation mode
0 - disable unsolicited result code (default)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions LE910 and is the answer not in the manual?

Telit Wireless Solutions LE910 Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelLE910
CategoryControl Unit
LanguageEnglish

Related product manuals