Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 473 of 509
Mod. 0808 2011-07 Rev.2
#JDRENH2 – Enhanced Jammed Detect & Report 2
<P_RSCP_T3G> - Set the threshold of RSCP in 3G Network. The threshold
(RSCP_Thr) is calculated as RSCP_Thr= RSCP_Av*(1-
(<
>/100)) where RSCP_Av is the average of the last 10 RSCP
measures.
0…100 (Factory default is 20).
All the parameter settings are saved in NVM memory.
Read command reports the current behaviour mode, in the format:
#JDRENH2:
<mode>
<
>
<
>
<
>
<
>
<
>
Test command reports the supported range of values for the parameters
#JDRENH2:
(<mode>)
<
>)
<
>)
<
>)
<
>)
<
P_EcN
0_T3G>),(<P_RSCP_T3G>),(0),(0),(0),(0)
LTE Jammed Detect & Report - #JDR4GCFG
#JDR4GCFG – LTE Jammed Detect & Report
R_T4G>[,<spare>[,<s
pare>[,<spare>[,<spa
re>[,<spare>[,<spare
>]]]]]]
Set command allows to configure the LTE Jammed Detect & Report feature.
Parameters:
<P_RSRP_T4G> - Set the threshold of RSRP. The threshold (RSRP_Thr) is
calculated as
RSRP_Thr= RSRP_Av*(1+(<P_RSRP_T4G>/100)) where RSRP_Av is the
average of the last 8 RSRP measures.
0..100(Factory default is 30)
<P_RSRQ_T4G> - Set the threshold of RSRQ. The threshold (RSRQ_Thr) is
calculated as
RSRQ_Thr= RSRQ_Av*(1-(<P_RSRQ_T4G>/100)) where RSRQ_Av is the
average of the last 8 RSRQ measures.
0..100(Factory default is 80)
<P_RSSNR_T4G> - Set the threshold of RSRP. The threshold (RSSNR_Thr) is
calculated as
RSSNR _Thr= RSSNR _Av*(1+(<P_RSSNR_T4G>/100)) where RSSNR _Av is
the average of the last 8 RSRP measures.
0..100(Factory default is 90)
To Next Page
Loading...
Need help?
General
