Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 184 of 509
Mod. 0808 2011-07 Rev.2
+CMGS: 1
Test command returns the OK result code.
To avoid malfunctions is suggested to wait for the +CMGS: <mr> or +CMS
ERROR: <err> response before issuing further commands.
Send Message From storage - +CMSS
+CMSS - Send Message From Storage
<da>[,<toda>]]
Execution command sends to the network a message which is already stored in the
<memw> storage (see +CPMS) at the location <index>.
Parameters:
<index> - location value in the message storage <memw> of the message to send
<da> - destination address, string type represented in the currently selected
character set (see +CSCS); if it is given it shall be used instead of the one stored
with the message.
<toda> - type of destination address
129 - number in national format
145 - number in international format (contains the "+")
If message is successfully sent to the network then the OK result is shown.
If message sending fails for some reason, an error code is reported:
+CMS ERROR:<err>
Note: to store a message in the <memw>storage see command +CMGW.
Note: care must be taken to ensure that during the command execution, which may
take several seconds, no other SIM interacting commands are issued.
Test command returns the OK result code.
Set Text Mode Parameters - +CSMP
+CSMP - Set Text Mode Parameters
k_addr>[,<tele_id>[,<
priority>[,<enc_type
>]]]]
Set command is used to select values for additional parameters for storing and
sending SMs when the text mode is used (AT+CMGF=1)
Parameters:
<callback_addr>- Callback address.
Note: The maximum length is different with every carrier.
In case of Sprint and Aeris.Net: Maximum length is 32 characters
In case of Verizon: Maximum length is 20 characters
Note: Initially, this parameter is null. Some carrier networks discard SMS's without
a callback number. Therefore, we recommend that customer setup callback
number using AT+CSMP command.
Note: The <callback_addr> isn’t used and saved for only Aeris.Net
To Next Page
Loading...
Need help?
General
