Telit Wireless Solutions LE910 - Page 183

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 183 of 509
Mod. 0808 2011-07 Rev.2
+CMGS - Send Message
SELINT 2
62626262626262626262626262626262626262626262
<user_data: bbbbbbbbbbbbbbbbbbbbbb>
AT+CMGS=31
>
07801091346554F307801091346554F31002020212C3870E1C3870E1C387162C5
8B162C58B1620
+CMGS: 3
OK
OK
07 <addr_len: 7byte>
80 <type_addr: 128>
1091346554F3 <destination_address:01194356453>
07 <addr_len: 7byte>
80 <type_addr: 128>
1091346554F3 <callback_address: 01194356453>
1002 <Teleservice_id: 4098(decimal)>
02 <priority: ungent >
02 <encoding_type: 7-bit ASCII >
12 <data_len: 18>
C3870E1C3870E1C387162C58B162C58B1620
<user_data: aaaaaaaaaabbbbbbbbbb>
(Text Mode)
AT+CMGS=
<da>
[,<toda>]
(Text Mode)
Execution command sends to the network a message.
Parameters:
<da>- destination address, string type represented in the currently selected
character set (see +CSCS);
ASCII characters in the set (0 9), #,*,(A D);
Note: The maximum length is different with every carrier.
In case of Sprint and Aeris.Net:
Maximum length is 32 characters
In case of Verizon:
Maximum length is 20 characters.
<toda>- type of destination address
129 - number in national format
145 - number in international format (contains the "+")
To send the message issue Ctrl-Z char (0x1A hex).
To exit without sending the message issue ESC char (0x1B hex).
If message is successfully sent to the network, then the result is sent in the format:
+CMGS: <mr>
where
<mr>- message reference number.
Note: if message sending fails for some reason, an error code is reported.
Note: To discard SMS, press the “ESC” key, an “OK” response will be returned.
Example – Text mode
AT+CMGF=1
OK
AT+CMGS="9194547830"