Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 309 of 509
Mod. 0808 2011-07 Rev.2
<service_1>,<life_data>,<current_time><CR><LF>#STATSCONSU
ME:
<service_2>,<life_data>,<current_time><CR><LF>…<CR><LF>#ST
ATSCONSUME: <service_12>,<life_data>,<current_time>
where
<service_i> is defined as <service_type> above
<life_data>
Number of data counted during entire life time period
<current_time>
Number of passed hours during entire life time period
Note: issuing AT#STATSCONSUME without parameters has the same
effect as AT#STATSCONSUME=0
Test command returns OK result code
Block/unblock a type of service - #BLOCKCONSUME
#BLOCKCONSUME – block/unblock a type of service
vice_type>,<block>
Execution command blocks/unblocks a type of service
Parameter:
<service_type>
Type of service:
1 – SMS Sending
2 – SMS Receiving
3 – SMS Sending/ Receiving
4 – CS MO Calls
5 – CS MT Calls
6 – MO/MT CS Calls
7 – IP Data
<block>
0 – unblock the service specified in <service_type>
1 – block the service specified in <service_type>
Note: even if the service “SMS Received” has been blocked, an SMS
ATRUN digest SMS can be received and managed.
Note: the type of service 7 “IP Data” comprises all the IP services (i.e.
IP ,with or without header, sent, receive and sent/receive data)
To Next Page
Loading...
Need help?
General
