Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 308 of 509
Mod. 0808 2011-07 Rev.2
0 – period counter: the command returns the values of period counters for
every rule defined with AT#CONSUMECFG command in the format:
#STATSCONSUME:
<rule_1>,<service_type>,<counted_data>,<threshold>,<current_time
>,<period><CR><LF>#STATSCONSUME:
<rule_2>,<service_type>,<counted_data>,<threshold>,<current_time
>,<period><CR><LF>….<CR><LF>>#STATSCONSUME:
<rule_10>,<service_type>,<counted_data>,<threshold>,<current_tim
e>,<period>
where
<rule_i>
Index of the rule defined with AT#CONSUMECFG
<service_type>
Type of service:
1 – SMS Sent
2 – SMS Received
3 – Total SMS
4 – CS MO Calls
5 – CS MT Calls
6 – Total CS Calls
7 – IP All Data Sent
8 – IP All Data Received
9 – IP All Data
10 – IP All Data Sent (with Header)
11 – IP All Data Received (with Header)
12 – IP All Data (with Header)
<counted_data>
Number of data counted during <current_time>
<threshold>
Limit amount of data to count (set in parameter <limit_amount> with
AT#CONSUMECFG)
<current_time>
Number of passed hours in the current <period>
<period>
Number of total hours in the period where the data are counted
(corresponds to the value set in <period> with AT#CONSUMECFG)
1 – life counter: the command returns the values of life counters for
every service type in the format:
To Next Page
Loading...
