EasyManuals Logo

Telit Wireless Solutions LE910 User Manual

Telit Wireless Solutions LE910
509 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #129 background imageLoading...
Page #129 background image
Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 129 of 509
Mod. 0808 2011-07 Rev.2
GPRS Event Reporting - +CGEREP
+CGEREP - GPRS Event Reporting
SELINT 2
AT+CGEREP=
[<mode>[,<bfr>]]
Set command enables or disables sending of unsolicited result codes +CGEV:
XXX (see below) from TA to TE in the case of certain events occurring in the TA
or the network.
Parameters:
<mode> - controls the processing of URCs specified with this command
0 - Buffer unsolicited result codes in the TA. If TA result code buffer is full, the
oldest one can be discarded. No codes are forwarded to the TE.
1 - Discard unsolicited result codes when TA-TE link is reserved (e.g. in on-line
data mode); otherwise forward them directly to the TE.
2 - Buffer unsolicited result codes in the TA when TA-TE link is reserved (e.g. in
on-line data mode) and flush them to the TE when TA-TE link becomes
available; otherwise forward them directly to the TE.
<bfr> - controls the effect on buffered codes when <mode> 1 or 2 is entered:
0 - TA buffer of unsolicited result codes defined within this command is cleared
when <mode>=1 or 2 is entered.
1 - TA
buffer of unsolicited result codes defined within this command is flushed to
the TE when <mode>=1 or 2 is entered (OK response shall be given before
flushing the codes)
Unsolicited Result Codes
The following unsolicited result codes and the corresponding events are defined:
+CGEV: REJECT <PDP_type>, <PDP_addr>
A network request for PDP context activation occurred when the TA was
unable to report it to the TE with a +CRING unsolicited result code and was
automatically rejected
+CGEV: NW REACT <PDP_type>, <PDP_addr>, [<cid>]
The network has requested a context reactivation. The <cid> that was used to
reactivate the context is provided if known to TA
+CGEV: NW DEACT <PDP_type>, <PDP_addr>, [<cid>]
The network has forced a context deactivation. The <cid> that was used to
activate the context is provided if known to TA
+CGEV: ME DEACT <PDP_type>, <PDP_addr>, [<cid>]
The mobile equipment has forced a context deactivation. The <cid> that was
used to activate the context is provided if known to TA
+CGEV: NW DETACH
The network has forced a GPRS detach. This implies that all active contexts
have been deactivated. These are not reported separately

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions LE910 and is the answer not in the manual?

Telit Wireless Solutions LE910 Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelLE910
CategoryControl Unit
LanguageEnglish

Related product manuals