Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 52 of 509
Mod. 0808 2011-07 Rev.2
4.1.3.4. S Parameters
Basic commands that begin with the letter “S” are known as “S-Parameters”. The number
following the “S” indicates the “parameter number” being referenced. If the number is not
recognized as a valid parameter number, an ERROR result code is issued.
If no value is given for the subparameter of an S-Parameter, an ERROR result code will be
issued and the stored value left unchanged.
Reference: V25ter
Note: what follows is a special way to set and read an
:
sets the contents of the last
accessed with ATSn=<value>
command (default: S0)
Example:
sets the content of
to 40
returns the current value of the last
accessed with ATSn=<value>
command (default: S0)
Number Of Rings To Auto Answer - S0
S0 - Number Of Rings To Auto Answer
Set command sets the number of rings required before device automatically
answers an incoming call.
Parameter:
<n> - number of rings
0 - auto answer disabled (factory default)
1..255 - number of rings required before automatic answer.
Read command returns the current value of S0 parameter.
Data only products ignore command setting and have auto answer disabled if
incoming call is a voice call.
Ring Counter - S1
To Next Page
Loading...
Need help?
General
