Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 143 of 509
Mod. 0808 2011-07 Rev.2
+CGEQOSRDP - parameter command syntax
<DL_MBR>: a numeric parameter which indicates DL MBR in case of GBR
QCI. The value is in kbit/s. This
parameter is omitted for a non-GBR QCI. (see 3GPP TS 24.301 [83])
<UL_MBR>: a numeric parameter which indicates UL MBR in case of GBR
QCI. The value is in kbit/s. This
parameter is omitted for a non-GBR QCI. (see 3GPP TS 24.301 [83])
+CGEQOSRDP: (list of <cid>s associated with active
contexts)
The test command returns a list of <cid>s associated with active contexts.
Parameters of both network and MT/TA initiated PDP contexts will be returned.
3G Quality Of Service Profile (Minimum Acceptable) - +CGEQMIN
+CGEQMIN – 3G Quality Of Service Profile (Minimum Acceptable)
[<cid>
[,<Traffic class>
[,<Maximum bitrate UL>
[,<Maximum bitrate DL>
UL>
DL>
[,<Delivery order>
[,<Maximum SDU size>
[,<SDU error ratio>
ratio>
[,<Delivery of erroneous
SDUs>
[,<Transfer delay>
[,<Traffic handling priority>
[,<Source statistics
descriptor> [,<Signalling
indication>]]]]]]]]]]]]]]]
Set command allows specifying a 3G quality of service profile for
the context identified by the (local) context identification parameter
which is checked by the MT against the negotiated profile
returned in the Activate/Modify PDP Context Accept Message.
Parameters:
- PDP context identification (see +CGDCONT command).
- Traffic class
0 – conversational (default value)
1 - streaming
2 - interactive
3 - background
- Maximum bitrate Up Link (kbits/s)
0 (default value)
1…8640
- Maximum bitrate down link (kbits/s)
0 (default value)
1…42200 ( not yet supported by Intel )
- the guaranteed bitrate up link(kbits/s)
0 (default value)
1…8640
To Next Page
Loading...
Need help?
General
