Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 231 of 509
Mod. 0808 2011-07 Rev.2
then power off the module. The proper SIM status will be available at the next
power on.
Read command reports whether the unsolicited indication #QSS is currently
enabled or not, along with the SIM status, in the format:
#QSS: <mode>,<status>
(<mode> and <status> are described above)
To get the proper SIM status, we strongly suggest to set <mode>=2 and save the
value in the user profile, then power off and power on the module.
Test command returns the supported range of values for parameter <mode>.
Delete all phonebook entries - #CPBD
#CPBD – Delete All Phonebook Entries
Execution command deletes all phonebook entries in the current phonebook
memory storage selected with +CPBS.
Test command tests for command existence
ATD Dialing Mode - #DIALMODE
[<mode>]
Set command sets dialing modality.
Parameter:
<mode>
0 - (voice call only) OK result code is received as soon as it starts remotely
ringing (factory default)
1 – (voice call only) OK result code is received only after the called party
answers. Any character typed aborts the call and OK result code is received.
2 - (voice call and data call) the following custom result codes are received,
monitoring step by step the call status:
DIALING (MO in progress)
RINGING (remote ring)
CONNECTED (remote call accepted)
RELEASED (after ATH)
DISCONNECTED (remote hang-up)
Any character typed before the CONNECTED message aborts the call
To Next Page
Loading...
Need help?
General
