Telit Wireless Solutions LE910 - Show PDP Address - +CGPADDR

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 149 of 509
Mod. 0808 2011-07 Rev.2
Show PDP Address - +CGPADDR
+CGPADDR - Show PDP Address
SELINT 2
AT+CGPADDR=
[<cid>[,<cid>
[,…]]]
Execution command returns a list of PDP addresses for the specified context
identifiers in the format:
+CGPADDR: <cid>,<PDP_addr>[<CR><LF>+CGPADDR: <cid>,
<PDP_addr>[…]]
Parameters:
<cid> - a numeric parameter which specifies a particular PDP context definition
(see +CGDCONT command). If no <cid> is specified, the addresses for all
defined contexts are returned.
<PDP_addr> - a string that identifies the terminal in the address space applicable
to the PDP. The address may be static or dynamic. For a static
address, it will be the one set by the +CGDCONT command when
the context was defined. For a dynamic address it will be the one
assigned during the last PDP context activation that used the
context definition referred to by <cid>; if no address is available
the empty string (“”) is represented as <PDP_addr>
AT+CGPADDR=?
Test command returns a list of defined <cid>s.
Example
AT#GPRS=1
+IP: xxx.yyy.zzz.www
OK
AT+CGPADDR=1
+CGPADDR: 1,”xxx.yyy.zzz.www”
OK
AT+CGPADDR=?
+CGPADDR: (1)
OK
Reference
3GPP TS 27.007