Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 238 of 509
Mod. 0808 2011-07 Rev.2
#MWI - Message Waiting Indication
0 - no waiting message indicator is currently set: if this the case no other
information is reported
1 - there are waiting messages related to the message waiting indicator
<indicator>.
<indicator>
1 - either Line 1 (CPHS context) or Voice (3GPP context)
2 - Line 2 (CPHS context)
3 - Fax
4 - E-mail
5 - Other
<count> - message counter: number of pending messages related to the message
waiting indicator <indicator> as it is stored on SIM.
Read command reports wheter the presentation of the message waiting indicator
URC is currently enabled or not, and the current status of the message waiting
indicators as they are currently stored on SIM. The format is:
#MWI: <enable>,<status>[,<indicator>[,<count>][<CR><LF>
#MWI: <enable>,<status>,<indicator>[,<count>][...]]]
Test command returns the range of available values for parameter <enable>.
Network Emergency Number Update - #NWEN
#NWEN – Network Emergency Number Update
Set command enables/disables unsolicited indication of emergency number
update.
Parameters:
<en>
0 - disables unsolicited indication of emergency number update (factory
default)
1 - enables unsolicited indication of emergency number update
#NWEN: <type>
where:
<type>
1 number list update from internal ME
2 number list update from SIM
3 number list update from network
Read command reports whether the unsolicited indication of network
emergency number update is currently enabled or not, in the format:
To Next Page
Loading...
Need help?
General
