Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 124 of 509
Mod. 0808 2011-07 Rev.2
+CSVM – Set Voice Mail Number
145 - international type of number and ISDN/Telephony
numbering plan (contains the character "+")
Note: Set command is dummy. It only checks for parameters
values validity; it does not send any actual write request to
SIM to update voice mail number, nor sends any request to
network to enable/disable voice mail..
Read command returns the currently selected voice mail number
and the status (i.e. enabled/disabled) in the format
+CSVM:<mode>,<number>,<type>
Test command reports the range for the parameters <mode> and
<type>.
Available AT Commands - +CLAC
+CLAC - Available AT Commands
Execution command causes the ME to return the AT commands that are available
for the user, in the following format:
<AT cmd1
>[<CR><LF
><AT cmd
2>[…]]
where:
<AT cmdn> - defines the AT command including the prefix AT
Test command returns the OK result code
To Next Page
Loading...
Need help?
General
