Telit Wireless Solutions LE910 - Socket Definition - #SKTSET; Socket Inactivity Time-Out - #SKTTO

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 389 of 509
Mod. 0808 2011-07 Rev.2
#DSTO -Data Sending Time-Out
SELINT 2
Note: this command is not allowed for sockets associated to a GSM context (see
#SCFG).
AT#DSTO?
Read command reports the current data sending time-out value.
AT#DSTO=?
Test command returns the allowed values for the parameter <tout>.
Example
AT#DSTO=10 ->1 sec. time-out
OK
AT#DSTO?
#DSTO: 10
OK
Socket Inactivity Time-Out - #SKTTO
#SKTTO - Socket Inactivity Time-Out
SELINT 2
AT#SKTTO=
[<tout>]
Set command sets the maximum time with no data exchanging on the socket that
the module awaits before closing the socket
Parameter:
<tout> - socket inactivity time-out in seconds units
0 - no time-out.
1..65535 - time-out in sec. units (factory default is 90).
Note: this time-out applies when no data is exchanged in the socket for a long time
and therefore the socket connection has to be automatically closed.
Note: this command is not allowed for sockets associated to a GSM context (see
#SCFG).
AT#SKTTO?
Read command reports the current socket inactivity time-out value.
AT#SKTTO=?
Test command returns the allowed values for parameter <tout>.
Example
AT#SKTTO=30 ->(30 sec. time-out)
OK
AT#SKTTO?
#SKTTO: 30
OK
Socket Definition - #SKTSET
#SKTSET - Socket Definition
SELINT 2
AT#SKTSET=
[<socket type>,
<remote port>,
<remote addr>,
[<closure type>],
[<local port>]]
Set command sets the socket parameters values.
Parameters:
<socket type> - socket protocol type
0 - TCP (factory default)
1 - UDP