Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 119 of 509
Mod. 0808 2011-07 Rev.2
Ringer Sound Level - +CRSL
+CRSL - Ringer Sound Level
Set command is used to select the incoming call ringer sound level of the device.
Parameter:
<level> - ringer sound level
0 - Off
1 - low
2 - middle
3 - high
Read command reports the current <level> setting of the call ringer in the format:
+CRSL: <level>
Test command reports <level> supported values as compound value.
To Next Page
Loading...
Need help?
General
