Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 394 of 509
Mod. 0808 2011-07 Rev.2
Socket TCP Connection Time-Out - #SKTCT
#SKTCT - Socket TCP Connection Time-Out
[<tout>]
Set command sets the TCP connection time-out for the first CONNECT answer
from the TCP peer to be received.
Parameter:
<tout> - TCP first CONNECT answer time-out in 100ms units
10..1200 - hundreds of ms (factory default value is 600).
Note: this time-out applies only to the time that the TCP stack waits for the
CONNECT answer to its connection request.
Note: The time for activate the GPRS and resolving the name with the DNS query
(if the peer was specified by name and not by address) is not counted in this time-
out.
Note: this command is not allowed for sockets associated to a GSM context (see
Read command reports the current TCP connection time-out.
Test command returns the allowed values for parameter <tout>.
OK
socket first connection answer time-out has been set to 60 s.
Socket Parameters Save - #SKTSAV
#SKTSAV - Socket Parameters Save
Execution command stores the current socket parameters in the NVM of the device.
The socket parameters to store are:
- User ID
- Password
- Packet Size
- Socket Inactivity Time-Out
- Data Sending Time-Out
- Socket Type (UDP/TCP)
- Remote Port
- Remote Address
- TCP Connection Time-Out
Note: this command is not allowed for sockets associated to a GSM context (see
Test command returns the OK result code.
To Next Page
Loading...
Need help?
General
