Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 78 of 509
Mod. 0808 2011-07 Rev.2
Calling Line Identification Restriction - +CLIR
+CLIR - Calling Line Identification Restriction
Set command overrides the CLIR subscription when temporary mode is provisioned
as a default adjustment for all following outgoing calls. This adjustment can be
revoked by using the opposite command. This command refers to CLIR-service
(GSM 02.81) that allows a calling subscriber to enable or disable the presentation of
the CLI to the called party when originating a call.
Parameter:
<n> - facility status on the Mobile
0 - CLIR facility according to CLIR service network status
1 - CLIR facility active (CLI not sent)
2 - CLIR facility not active (CLI sent)
Read command gives the default adjustment for all outgoing calls (<n>) and also
triggers an interrogation of the provision status of the CLIR service (<m>), where
<n> - facility status on the Mobile
0 - CLIR facility according to CLIR service network status
1 - CLIR facility active (CLI not sent)
2 - CLIR facility not active (CLI sent)
<m> - facility status on the Network
0 - CLIR service not provisioned
1 - CLIR service provisioned permanently
2 - unknown (e.g. no network present, etc.)
3 - CLI temporary mode presentation restricted
4 - CLI temporary mode presentation allowed
Test command reports the supported values of parameter <n>.
This command sets the default behaviour of the device in outgoing calls.
To Next Page
Loading...
Need help?
General
