EasyManuals Logo

Telit Wireless Solutions LE910 User Manual

Telit Wireless Solutions LE910
509 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 77 of 509
Mod. 0808 2011-07 Rev.2
+CLIP - Calling Line Identification Presentation
SELINT 2
128 - both the type of number and the numbering plan are unknown
129 - unknown type of number and ISDN/Telephony numbering plan
145 - international type of number and ISDN/Telephony numbering plan (contains
the character "+")
<alpha> - string type; alphanumeric representation of <number> corresponding to
the entry found in phonebook; used character set should be the one
selected with command Select TE character set +CSCS.
<CLI_validity>
0 - CLI valid
1 - CLI has been withheld by the originator.
2 - CLI is not available due to interworking problems or limitation or originating
network.
Note: in the +CLIP: response they are currently not reported either the subaddress
information (it’s always “” after the 2
nd
comma) and the subaddress type
information (it’s always 128 after the 3
rd
comma)
AT+CLIP?
Read command returns the presentation status of the CLI in the format:
+CLIP: <n>,<m>
where:
<n>
0 - CLI presentation disabled
1 - CLI presentation enabled
<m> - status of the CLIP service on the GSM network
0 - CLIP not provisioned
1 - CLIP provisioned
2 - unknown (e.g. no network is present )
Note: This command issues a status request to the network, hence it may take a few
seconds to give the answer due to the time needed to exchange data with it.
AT+CLIP=?
Test command returns the supported values of parameter <n>
Reference
3GPP TS 27.007
Note
The command changes only the report behaviour of the device, it does not change
CLI supplementary service setting on the network.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions LE910 and is the answer not in the manual?

Telit Wireless Solutions LE910 Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelLE910
CategoryControl Unit
LanguageEnglish

Related product manuals