Telit Wireless Solutions LE910 - Enable Evmoni Service - #ENAEVMONI; Event Monitor Commands

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 313 of 509
Mod. 0808 2011-07 Rev.2
#CSFB – Circuit Switched Fallback
<lcs_client_identity>
where:
<m>:
Notification parameter
0 - No user response required. This could be because of last user
settings AT#CSFB=2 or 3.
1 - User response required. User should respond with AT#CSFB=4 or 5.
2 - CSFB operation failed due to some error.
<ph_no>:
string with the identification of the calling line for the mobile
terminating call in the CS domain, which triggered the paging via SGs.
<ss_code>:
information on the supplementary service transaction in
the CS domain, which triggered the paging via SGs.
<lcs_indicator>
: indicates that the paging was triggered by a
terminating LCS request in the CS domain.
<lcs_client_identity>:
string with the information related to the
requestor of the terminating LCS request in the CS domain.
Note 1: options 4 and 5 has to be sent only when the CSFB
indication(URC) is sent with <m> = 1.
Note 2: options 4 and 5 will not be reported in AT#CSFB? command.
Note 3: In case CSFB indication is reported and there is no answer
before the timer expires, a timeout scenario is handled.
Note 4: the setting is saved in NVM.
AT#CSFB?
Read command returns the currently configured values, in the format:
#CSFB
:
< mode >
AT#CSFB =?
Test command returns the supported range of values of parameters <
mode>
#CSFB: (0-5)
4.1.6.5. Event Monitor Commands
Enable EvMoni Service - #ENAEVMONI
#ENAEVMONI – Enable EvMoni Service
SELINT 2
AT#ENAEVMONI=
Set command enables/disables the EvMoni service.