Telit Wireless Solutions LE910 - AT Command Delay - #ATDELAY

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 322 of 509
Mod. 0808 2011-07 Rev.2
AT Command Delay - #ATDELAY
#ATDELAY – AT Command Delay
SELINT 2
AT#ATDELAY=
<delay>
Set command sets a delay in second for the execution of following AT command.
Parameters:
<delay> - delay in 100 milliseconds intervals; 0 means no delay
Note: <delay> is only applied to first command executed after #ATDELAY
AT#ATDELAY=?
Test command returns the supported range of values for parameter
<delay>
Example
Delay “at#gpio=1,1,1” execution of 5 seconds:
at#gpio=1,0,1;#atdelay=50;#gpio=1,1,1
OK