Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 233 of 509
Mod. 0808 2011-07 Rev.2
Automatic call - #ACAL
[<mode>]
Set command enables/disables the automatic call function.
Parameter:
<mode>
0 - disables the automatic call function (factory default)
1 - enables the automatic call function. If enabled (and &D2 has been issued), the
transition OFF/ON of DTR causes an automatic call to the first number
(position 0) stored in the internal phonebook.
Note: type of call depends on the last issue of command +FCLASS.
Read command reports whether the automatic call function is currently enabled or
not, in the format:
#ACAL: <mode>
Note: as a consequence of the introduction of the command #ACALEXT
(Extended Automatic Call) it is possible that the Read Command returns a value
supported by #ACALEXT but NOT supported by #ACAL.
AT#ACAL?
#ACAL : 2
OK
Due to this possible situation it is strongly recommended not to use
contemporaneously both commands.
Test command returns the supported range of values for parameter <mode>.
See &Z to write and &N to read the number on module internal phonebook.
To Next Page
Loading...
Need help?
General
