Telit Wireless Solutions LE910 - Page 232

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 232 of 509
Mod. 0808 2011-07 Rev.2
#DIALMODE - Dialing Mode
SELINT 2
Note: In case a BUSY tone is received and at the same time ATX0 is enabled ATD
will return NO CARRIER instead of DISCONNECTED.
Note: The setting is saved in NVM and available on following reboot.
AT#DIALMODE?
Read command returns current ATD dialling mode in the format:
#DIALMODE: <mode>
AT#DIALMODE=?
Test command returns the range of values for parameter <mode>