Telit Wireless Solutions LE910 User Manual

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 186 of 509
Mod. 0808 2011-07 Rev.2
+CSAS - Save Settings
SELINT 2
Note: If parameter is omitted the settings are saved to profile 0 in the non-volatile
memory.
AT+CSAS=?
Test command returns the possible range of values for the parameter <profile>.
Example
AT+CSAS=?
+CSAS: (0)
OK
AT+CSAS
OK
AT+CSAS=0
OK
Restore Settings - +CRES
+CRES - Restore Settings
SELINT 2
AT+CRES[=
[<profile>]
Execution command restores message service settings saved by +CSAS command
from NVM.
Parameter:
<profile>
0 - it restores message service settings from NVM.
Note: If parameter is omitted the command restores message service settings from
NVM.
AT+CRES=?
Test command returns the possible range of values for the parameter <profile>.
Example
AT+CRES=?
+CRES: (0)
OK
AT+CRES
OK
AT+CRES=0
OK
4.1.6. Custom AT Commands
4.1.6.1. General Configuration AT Commands
Hang Up Call - #CHUP
#CHUP - Hang Up Call
SELINT 2
AT#CHUP
Execution command ends all active and held calls, also if a multi-party
session is running. It also allows disconnecting of a data call from a CMUX
instance different from the one that was used to start the data call.
AT#CHUP=?
Test command returns the OK result code

Telit Wireless Solutions LE910 Specifications

General

Brand	Telit Wireless Solutions
Model	LE910
Category	Control Unit
Language	English