Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 312 of 509
Mod. 0808 2011-07 Rev.2
// TCP will be the transmission protocol;
// connection will be opened with “remoteHost”/remotePort
at#sgact=1,1
#SGACT: xxx.xxx.xxx.xxx
OK
at#ssendline="test sample"
// TCP connection with “remoteHost”/remotePort is opened ,
// data between double quotes are sent,
// then TCP connection is closed
Circuit Switched Fallback - #CSFB
#CSFB – Circuit Switched Fallback
This command is available for LE910-xx V2 variants supporting with
2G/3G fallback technologies.
Set command configures the mode of operation for Circuit Switched
Fallback.
Parameter:
<n>: unsolicited and mode of operation for Circuit Switched Fallback
0 - disable reporting of CSFB related CS paging requests and disable
automatic acceptance/rejection of CSFB calls.
1 - enable reporting of CSFB related CS paging requests and disable
automatic acceptance/rejection of CSFB calls.
2 - enable reporting of CSFB related CS paging requests and enable
automatic acceptance of CSFB calls. CSFB is always preferred over PS.
(default)
3 - enable reporting of CSFB related CS paging requests and enable
automatic rejection of CSFB calls.
4 - accept CSFB call. This value can be used only after having received
the unsolicited result code #CSFBI.
5 - reject CSFB call. This value can be used only after having received
the unsolicited result code #CSFBI.
The format of the enabled unsolicited is:
#CSFBI: <m>,<ph_no>,<ss_code>,<lcs_indicator>,
To Next Page
Loading...
Need help?
General
