Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 448 of 509
Mod. 0808 2011-07 Rev.2
Parameter:
<level>: handset analogue output gain
0..6 - handset analogue output (-3dB/step, default value = 0)
Note: This parameter is saved in NVM issuing AT&W command.
Read command returns the current handset analog output gain, in the format:
Test command returns the supported range of values of parameter <level>.
Set Handset Sidetone - #SHSSD
#SHSSD - Set Handset Sidetone
<mode>
Set command enables/disables the sidetone on handset audio output.
Parameter:
<mode>
0 - disables the handset sidetone (factory default)
1 - enables the handset sidetone
Note: This parameter is saved in NVM issuing AT&W command.
Read command reports whether the headset sidetone is currently enabled or not, in
the format:
Test command returns the supported range of values of parameter <mode>.
Speaker Mute Control - #SPKMUT
#SPKMUT - Speaker Mute Control
Set command enables/disables the global muting of the speaker audio line,
for every audio output ( ring, incoming sms, voice, Network coverage)
Parameter:
<n>
0 - mute off, speaker active (factory default)
1 - mute on, speaker muted.
Note: this command mutes/activates both speaker audio paths, internal speaker and
Read command reports whether the muting of the speaker audio line during a voice
call is enabled or not, in the format:
To Next Page
Loading...
Need help?
General
