Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 150 of 509
Mod. 0808 2011-07 Rev.2
Modify PDP context - +CGCMOD
+CGCMOD – Modify PDP context
[,<cid2>[,…,<cidN>]]]
The execution command is used to modify the specified PDP context(s)
with respect to QoS profiles.
If no <cidi> is specified the command modifies all active contexts.
Parameters:
<cidi>:
a numeric parameter which specifies a particular PDP context
Test command returns a list of <cid>s associated with active contexts.
Printing IP Address Format - +CGPIAF
+CGPIAF - Printing IP Address Format
AT+CGPIAF=
[<IPv6_AddressFo
rmat>[,<IPv6_Sub
netNotation>[,<IPv
6_leadingZeros>[,
<IPv6_compressZ
eros>]]]]
Set command decides what the format to print IPv6 address parameter.
- decides the IPv6 address format. Relevant for all
AT command parameters that can hold an IPv6 address.
0 – Use IPv4-like dot-notation. IP addresses, and subnetwork mask if
applicable, are dot-separated.
1 – Use IPv6-like colon-notation. IP address, and subnetwork mask if
applicable and when given explicitly, are separated by a space.
- decides the subnet-notation for <remote address
and subnet mask>
Setting does not apply if IPv6 address format
= 0.
0 – Both IP address, and subnet mask are started explicitly, separated by a
space.
1 – The printout format is applying /(forward slash) subnet-prefix Classless
Inter-Domain Routing (CIDR) notation.
- decides whether leading zeros are omitted or not.
Setting does not apply if IPv6 address format
= 0.
0 – Leading zeros are omitted.
1 – Leading zeros are included.
- decides whether 1-n instances of 16-bit- zero-
values are replaced by only “::”. This applies only once. Setting does not apply
if IPv6 address format
= 0.
To Next Page
Loading...
Need help?
General
