Telit Wireless Solutions LE910 - Send Message - #CMGS

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 319 of 509
Mod. 0808 2011-07 Rev.2
#EVMONI – Set the single Event Monitoring
SELINT 2
AT# EVMONI?
Read command returns the current settings for each event in the format:
#EVMONI: <label>,<mode>,<param0>[,<param1>[,<param2>[,<param3>]]]
Where <param0>, <param1>, <param2> and <param3> are defined as before
for <param> depending on <label> value
AT#EVMONI=?
Test command returns values supported as a compound value
Send Message - #CMGS
#CMGS - Send Message
SELINT 2
(PDU Mode)
AT#CMGS=
<length>,<pdu>
(PDU Mode)
Execution command sends to the network a message.
Parameter:
<length> - length of the PDU to be sent in bytes (excluding the SMSC address
octets).
7..164
<pdu> - PDU in hexadecimal format (each octet of the PDU is given as two
IRA character long hexadecimal number) and given in one line.
Note: when the length octet of the SMSC address (given in the <pdu>) equals
zero, the SMSC address set with command +CSCA is used; in this case the
SMSC Type-of-Address octet shall not be present in the <pdu>.
If message is successfully sent to the network, then the result is sent in the
format:
#CMGS: <mr>
where
<mr> - message reference number; 3GPP TS 23.040 TP-Message-Reference
in integer format.
Note: if message sending fails for some reason, an error code is reported.
(Text Mode)
AT#CMGS=<da>
,<text>
(Text Mode)
Execution command sends to the network a message.
Parameters:
<da> - destination address, string type represented in the currently selected
character set (see +CSCS).
<text> - text to send