Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 318 of 509
Mod. 0808 2011-07 Rev.2
#EVMONI – Set the single Event Monitoring
o if <paramType> = 2, <param> indicates the status high or low
under monitoring. The values are 0 (low) and 1 (high) . (Default: 0)
o if <paramType> = 3, <param>
indicates the time interval in
seconds after that the selected GP
IO pin in the status specified with
<paramType> = 1 causes the event. The range is 0 – 255. (Default:
0)
• If <label> is ADCH1, <paramType> can assume values in the range 0 - 3.
o if <paramType> = 1, <param>
indicates the ADC pin number;
supported range is from 1 to a value that depends on the hardware.
(Default: 1)
o if <paramType> = 2, <param>
indicates the ADC High voltage
threshold in the range 0 – 2000 mV. (Default: 0)
o if <paramType> = 3, <param>
indicates the time interval in
seconds after that the selected
ADC pin above the value specified
with <paramType> = 1 causes the event. The range is 0 – 255.
(Default: 0)
• If <label> is ADCL1, <paramType> can assume values in the range 0 - 3.
o if <paramType> = 1, <param>
indicates the ADC pin number;
supported range is from 1 to a value that depends on the hardware.
(Default: 1)
o if <paramType> = 2, <param>
indicates the ADC Low voltage
threshold in the range 0 – 2000 mV. (Default: 0)
o if <paramType> = 3, <param>
indicates the time interval in
seconds after that the selec
ted ADC pin under the value specified
with <paramType> = 1 causes the event. The range is 0 – 255.
(Default: 0)
• If <label> is DTMFX, <paramType> can assume values in the range 0 - 2.
o if <paramType> = 1, <param>
indicates the DTMF string; the
single DTMF characters have to belong to the range ((0-9),#,*,(A-
D)); the maximum number of characters in the string is 15
o if <paramType> = 2, <param>
indicates the timeout in
milliseconds. It is the maximum time interval within which a DTMF
tone must be detected after detecting the previous one, to be
considered as belonging to the DTMF string. The range is (500 –
5000). (Default: 1000)
• If <label> is SMSIN, <paramType> can assume values in the range 0-1.
o if <paramType> = 1, <param>
indicates the text that must be
received in incoming SMS to trigger AT command execution rings
after that the event occurs; the maximum number of characters in the
SMS text string is 15
. If no text is specified, AT command execution
is triggered after each incoming SMS
• If <label> is CONSUMEX, <paramType> can assume only the value 0.
Note: the DTMF string monitoring is available only if the DTMF decode has been
enabled (see #DTMF command)
To Next Page
Loading...
