Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 66 of 509
Mod. 0808 2011-07 Rev.2
+CR - Service Reporting Control
REL SYNC - synchronous non-transparent.
Note: this command replaces V.25ter [14] command Modulation Reporting Control
(+MR), which is not appropriate for use with a GSM terminal.
Read command returns whether or not intermediate result code +CR is enabled, in
the format:
Test command returns the supported range of values of parameter <mode>.
Extended Error Report - +CEER
+CEER - Extended Error Report
Execution command returns one or more lines of information text <report>
offering the TA user an extended error report, in the format:
+CEER: <report>
This report regards some error condition that may occur:
• the failure in the last unsuccessful call setup (originating or answering)
• the last call release
Note: if none of the previous conditions has occurred since power up then
“Normal, unspecified” condition is reported
Test command returns OK result code.
3GPP TS 27.007, GSM 04.08
Cellular Result Codes - +CRC
+CRC - Cellular Result Codes
[<mode>]
Set command controls whether or not the extended format of incoming call
indication is used.
Parameter:
<mode>
0 - disables extended format reporting (factory default)
1 - enables extended format reporting:
When enabled, an incoming call is indicated to the TE with unsolicited result code
+CRING: <type>
To Next Page
Loading...
Need help?
General
