Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 71 of 509
Mod. 0808 2011-07 Rev.2
+COPS - Operator Selection
2 - deregister from GSM network; the MODULE is kept unregistered until a
+COPS with <mode>=0, 1 or 4 is issued
3 - set only <format> parameter (the parameter <oper> will be ignored)
4 - manual/automatic (<oper> field shall be present); if manual selection fails,
automatic mode (<mode>=0) is entered
<format>
0 - alphanumeric long form (max length 16 digits)
2 - Numeric 5 or 6 digits [country code (3) + network code (2 or 3)]
<oper>: network operator in format defined by <format> parameter.
<AcT> access technology selected:
0 GSM
2 UTRAN
7 E-UTRAN
Note: <mode> parameter setting is stored in NVM and available at next reboot, if it
is not 3 (i.e.: set only <format> parameter).
Note: if <mode>=1 or 4, the selected network is stored in NVM too and is
available at next reboot (this will happen even with a new SIM inserted)
Note: <format> parameter setting is never stored in NVM
Note: 3G only products support <AcT> parameter value 2 only.
Note: 4G only products support <AcT> parameter value 7 only.
Read command returns current value of <mode>,<format>,<oper> and <AcT> in
format <format>; if no operator is selected, <format>, <oper> and <AcT> are
omitted
+COPS: <mode>[, <format>, <oper>,< AcT>]
Where
<AcT> access technology selected:
0 GSM
2 UTRAN
3 GSM w/EGPRS
4 UTRAN w/HSDPA
5 UTRAN w/HSUPA
6 UTRAN w/HSDPA and HSUPA
7 E-UTRAN
Test command returns a list of quadruplets, each representing an operator present in
the network.
The quadruplets in the list are separated by commas: