Telit Wireless Solutions LE910 - Page 249

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 249 of 509
Mod. 0808 2011-07 Rev.2
#CCLKMODE – Clock Mode
SELINT 2
Parameter:
<mode> - time and date mode
0 - Local time + local time zone offset (default)
1 – UTC time + local time zone offset
Note: the setting is saved automatically in NVM.
AT#CCLKMODE?
Read command reports whether the local time or the UTC time is enabled, in the
format:
#CCLKMODE: <mode>
(<mode> described above)
AT#CCLKMODE=?
Test command reports the supported range of values for parameter <mode>
Example:
at#cclkmode?
#CCLKMODE: 0
OK
#NITZ: 13/03/05,15:20:33+04,0
at+cclk?
+CCLK: "13/03/05,15:20:37+04"
OK
at#cclkmode=1
OK
at+cclk?
+CCLK: "13/03/05,14:20:45+04"
OK
at#cclkmode?
#CCLKMODE: 1
OK
#NITZ: 13/03/05,14:20:53+04,0
at+cclk?
+CCLK: "13/03/05,14:20:55+04"
OK
at#cclkmode=0
OK
at+cclk?
+CCLK: "13/03/05,15:20:59+04"
OK