Telit Wireless Solutions LE910 - Page 443

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 443 of 509
Mod. 0808 2011-07 Rev.2
#STACFG – Configure SIM Toolkit Application parameters
SELINT 2
AT#STACFG=<instance> [,
<UNUSED_1>[,
<UNUSED_2>]
Set command configures the SIM Toolkit Application.
Parameters:
<instance>:
AT instance that will be used by the SIM Toolkit Application (see
#STTA).
Range 1 - 5, default 3.
<UNUSED_1>: reserved for future use
<UNUSED_2>: reserved for future use
Note: <instance> parameter can be setted only if <state> parameter of
#STTA is set to 0, otherwise the set command returns ERROR.
Note: an ERROR is issued if <UNUSED_1> and <UNUSED_2>
parameters are set with a value different from 0.
AT#STACFG?
Read command returns the current settings of parameters in the
format:
# STACFG:<instance>,0,0
AT#STACFG =?
Test command returns the supported values for the #STACFG
parameters