To Next Page

To Previous Page

Telit LE910 V2 Series AT Commands

80446ST10707A Rev. 0– 2015-11-03

Mod. 0808 2011-07 Rev.2

#SWMBOOTSTRAP – Configure Bootstrap

<serverURL> - string parameter indicating the URL of the SWM server

in address:port form. The address substring shall start with “http://” or

“https://”, otherwise an error is raised.

<serverAuthType> - integer parameter indicating the authentication type

at the server side:

0 – BASIC

1 – DIGEST

2 – MD5

<serverAuthName> - string parameter indicating the username in the

server authentication

<serverAuthSecret> - string parameter indicating the password in the

server authentication

<serverAuthData> - string parameter indicating the nonce in the server

authentication

<clientAuthType> -

integer parameter indicating the authentication type at

the client side:

0 – BASIC

1 – DIGEST

2 – MD5

<clientAuthName> - string parameter indicating the username in the client

authentication

<clientAuthSecret> - string parameter indicating the password in the

client authentication

<clientAuthData> - string parameter indicating the nonce in the client

authentication

Note: the command is allowed only if SWM Client is enabled (i.e.

AT#SWMENA? answers 1 for <mode> parameter)

AT#SWMBOOTSTRAP?

Read command reports the current values of parameters in the format:

#SWMBOOTSTRAP:

<serverId>,<name>,<serverURL>,<serverAuthType>,<serverAuthNa

me>,<serverAuthSecret>,<serverAuthData>,<clientAuthType>,<client

AuthName>,<clientAuthSecret>,<clientAuthData>

The showed values are those of the tree.

Telit Wireless Solutions LE910 User Manual

Questions and Answers: