Telit Wireless Solutions LE910 - Page 225

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 225 of 509
Mod. 0808 2011-07 Rev.2
#SERVINFO - Serving Cell Information
SELINT 2
<PB-ARFCN> -
• if PBCCH is supported by the cell
o
if its content is the PBCCH ARFCN of the serving cell, then
<PB-ARFCN> is available
o else the label “hopping” will be printed
• else <PB-ARFCN> is not available
<NOM> - Network Operation Mode
..”I”
“II”
..”III”
<RAC> - Routing Area Colour Code
<PAT> - Priority Access Threshold
..0
..3..6
<UARFCN> - UMTS ARFCN of the serving cell
<PSC> - Primary Synchronisation Code
<DRX> - Discontinuous reception cycle length
<SD> - Service Domain
0 – No Service
1 – CS Only
2 – PS Only
3 – CS & PS
<RSCP> - Received Signal Code Power in dBm
During a call, a SMS sending/receiving or a location update the value of
<GPRS>, <PB-ARFCN>, <NOM>, <RAC> and <PAT> parameters don’t
make sense.
AT#SERVINFO=?
Test command tests for command existence.