Telit Wireless Solutions LE910 - Page 243

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 243 of 509
Mod. 0808 2011-07 Rev.2
#PSNT – Packet Service Network Type
SELINT 2
(<mode> = 2)
#PSNT: <mode>,<nt>,<is_hsupa_available>,<
is_hsupa_used>,<is_hsdpa_available>,<is_hsdpa_used>
(<mode> = 0 or <mode> = 1)
#PSNT: <mode>,<nt>
where
<mode>
0 - PSNT unsolicited result code disabled
1 - PSNT unsolicited result code enabled
2 - PSNT unsolicited result code enabled; read command reports
HSUPA and HSDPA related info
<nt> - network type
0 - GPRS network
1 - EGPRS network
2 - WCDMA network
3 - HSDPA network
4 – LTE network
5 - unknown or not registered.
.
<is_hsupa_available> - HSUPA available
0 – HSUPA is not supported by network
1 – HSUPA is supported by network
<is_hsupa_used> - HSUPA used
0 – HSUPA is not in use
1 – HSUPA is in use
<is_hsdpa_available> - HSDPA available
0 – HSDPA is not supported by network
1 – HSDPA is supported by network
<is_hsdpa_used> - HSPA used
0 – HSDPA is not in use
1 – HSDPA is in use