Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 218 of 509
Mod. 0808 2011-07 Rev.2
c. 3
rd
to 8
th
rows report a reduced set of GSM-related information for the
cells in the neighbours:
#MONI:
N<n>
<bsi
c>
<lac
>
<id> <arf
cn>
<dBm
>
<C
1value> <C2value>[<CR><LF>]
where:
<C1value> - C1 reselection parameter
<C2value> - C2 reselection parameter
other parameters as before
(UMTS network)
b. First row reports a set of information for the serving cell:
#MONI: <netname> PSC:<psc> RSCP:<rscp> LAC:<lac>
Id:<id>EcIo:<ecio> UARFCN:<uarfcn> PWR:<dBm> dBm DRX:<drx>
SCR:<scr>
b. the other rows report a set of information for all detected neighbour cells:
#MONI:
PSC:<psc
> RSCP:
<rscp> EcI
o:<eci
o> UARFCN:<u
arfcn>
SCR:<scr>
See above for parameters description.
Test command reports the maximum number of cells, in the neighbour list of the
serving cell excluding it, from which we can extract GSM/UMTS-related
information, along with the ordinal number of the current selected cell, in the
format:
#MONI: (<MaxCellNo>,<CellSet>)
where:
<MaxCellNo> - maximum number of cells, in the neighbour list of the serving cell
and excluding it, from which we can extract GSM-related
information. This value is always 6.
<CellSet> - the last setting done with command #MONI.
Set command selects the cell 0 in GSM network
at#moni=0
OK
Execution command reports GSM-related information for cell 0
at#moni
#MONI: I WIND BSIC:70 RxQual:0 LAC:55FA Id:1D23 ARFCN:736 PWR:-83dbm TA:1
Set command selects the cell 0 in UMTS network
To Next Page
Loading...
Need help?
General
