Telit Wireless Solutions LE910 - Page 220

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 220 of 509
Mod. 0808 2011-07 Rev.2
#MONIZIP – Compressed Cell Monitor
SELINT 2
0..6 - it is the ordinal number of the cell, in a the neighbour list of the serving cell
(default 0, serving cell).
7 - it is a special request to obtain GSM-related information from the whole set of
seven cells in the neighbour list of the serving cell.
(UMTS network)
0 – it is the serving cell in idle; Active set cells are also reported in CELL_DCH
state, i.e. during a call (default)
1 – it is the candidate set ( cells that belong to the Active set, only reported in
CELL_DCH state, i.e. during a call)
2 – it is the synchronized neighbour set (cells that belong to the Virtual Active set,
only reported in CELL_DCH state, i.e. during a call)
3 –
it is the asynchronized neighbour set (cells which are not suitable cells to camp
on)
4 – it is the ranked neighbour set (cells which are suitable cells to camp on)
7 - it is a special request to obtain information from the whole set of detected cells
in the neighbour list of the serving cell.
5..6 – it is not available
<LTE network>
0 – it is the serving cell
1 – it is the intra-frequency cells
2 – it is the inter-frequency cells
3 – it is the WCDMA neighbour cells
4 – it is the GSM neighbour cells
5..7 – it is not available
Execution command (AT#MONIZIP<CR>) reports GSM/UMTS/LTE-related
information for selected cell and dedicated channel (if exists).
1. If the last setting done by #MONIZIP is in the range [0..6], the output format
is as follows:
g) When extracting data for the serving cell the format is:
(GSM network)
#MONIZIP:
<cc><nc>,<bsic>,<qual>,<lac>,<id>,<arfcn>,<dBm>,<timadv>
(UMTS network)
#MONIZIP: <cc><nc>,<psc>,<rscp>,<lac>,<id>,<ecio>,
<uarfcn>,<dBm>,<drx>,<scr>
(LTE network)
#MONIZIP:
<netmame>,<rsrp>,<rsrq>,<tac>,<id>,<earfcn>,<dBm>,<drx>