Telit Wireless Solutions LE910 - Page 221

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 221 of 509
Mod. 0808 2011-07 Rev.2
#MONIZIP – Compressed Cell Monitor
SELINT 2
h) When extracting data for an adjacent cell (or active set cell), the format is:
(GSM network)
#MONIZIP: <lac>,<id>,<arfcn>,<dBm>
(UMTS network)
#MONIZIP: <psc>,<rscp>,<ecio>,<uarfcn>,<scr>
(LTE network)
(LTE intra-frequency and inter-frequency cells)
#MONI: <rsrp>,<rsrq>,<id>,<earfcn>,<dBm>
(LTE WCDMA neighbour cells)
#MONI: <psc>,<rscp>,<ecio>,<uarfcn>,<scr>
(LTE GSM neighbour cells)
#MONI: <n>,<bsic>,<arfcn>,<dBm>
where:
<cc> - country code
<nc> - network operator code
<n> - progressive number of adjacent cell
<bsic> - base station identification code
<qual> - quality of reception
0..7
<lac> - localization area code
<id> - cell identifier
<arfcn> - assigned radio channel
<dBm> - received signal strength in dBm
<timadv> - timing advance
<psc> - Primary Scrambling Code
<rscp> - Received Signal Code Power in dBm; for serving cell this is not
available during a call, and is displayed as 255
<ecio> - chip energy per total wideband power in dBm; for serving cell this is
not available during a call, and is displayed as 255
<uarfcn> - UMTS assigned radio channel
<drx> - Discontinuous reception cycle length
<scr> - Scrambling code
<rsrp> - Reference Signal Received Power
<rsrq> - Reference Signal Received Quality
<tac> - Tracking Area Code
<earfcn> - E-UTRA Assigned Radio Channel
<ura_id> - UTRAN Registration Area Identity
Note: TA: <timadv> is reported only for the serving cell.