Telit Wireless Solutions LE910 - Page 288

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 288 of 509
Mod. 0808 2011-07 Rev.2
#CSURVC - Network Survey (Numeric Format)
SELINT 2
<ba n > - decimal number; it is the arfcn of a valid channel in the BA list ( n
is in the range
1..<numChannels>
); the output of this
information for non-serving cells depends on last
#CSURVEXT
setting:
1. if
#CSURVEXT=0
this information is displayed only for
serving cell
2. if
#CSURVEXT=1, 2 or 3
this information is displayed also
for every valid scanned BCCH carrier.
(The following informations will be printed only if GPRS is supported in the
cell)
<pbcch
> - packet broadcast control channel
0 - pbcch not activated on the cell
1 - pbcch activated on the cell
<nom
> - network operation mode
1
2
3
<rac
> - routing area code
0..255 -
<spgc
> - SPLIT_PG_CYCLE support
..0 - SPLIT_PG_CYCLE is not supported on CCCH on this cell
..1 - SPLIT_PG_CYCLE is supported on CCCH on this cell
<pat>
- priority access threshold
0 -
3..6 -
<nco>
- network control order
0..2 -
<t3168>
- timer 3168
<t3192>
- timer 3192
<drxmax>
- discontinuous reception max time (in seconds)
<ctrlAck>
- packed control ack
<bsCVmax> -
blocked sequenc countdown max value
<alpha> -
alpha parameter for power control
<pcMeasCh> -
type of channel which shall be used for downlink
measurements for power control
0 - BCCH
1 - PDCH
(The following informations will be printed only for #CSURVEXT=3 setting)
<mstxpwr> - decimal TX power level
<rxaccmin> - decimal RX level access min, range 0 - 63