Telit Wireless Solutions LE910 - Page 156

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 156 of 509
Mod. 0808 2011-07 Rev.2
+CSCA -Service Center Address
SELINT 2
Note: in Text mode, this setting is used by send and write commands; in PDU
mode, setting is used by the same commands, but only when the length of the
SMSC address coded into the <pdu> parameter equals zero.
Note: the current settings are stored through +CSAS
AT+CSCA?
Read command reports the current value of the SCA in the format:
+CSCA: <number>,<type>
Note: if SCA is not present the device reports an error message.
AT+CSCA=?
Test command returns the OK result code.
Reference
3GPP TS 27.005