Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 200 of 509
Mod. 0808 2011-07 Rev.2
1 - it enables the presentation of the temperature monitor URC, whenever the
module internal temperature reaches either operating or extreme levels; the
unsolicited message is in the format:
#TEMPMEAS: <level>,<value>
where:
<level> and <value> are as before
<action> - sum of integers, each representing an action to be done whenever the
module internal temperature reaches either operating or extreme levels
(default is 0). If <action> is not zero, it is mandatory to set the
<hyst_time> parameter too.
0..7 - as a sum of:
0 - no action
1 - automatic shut-down when the temperature is beyond the extreme
bounds
2 - RF RX and TX circuits automatically disabled (using +CFUN=4) when
operating temperature bounds are reached. When the temperature is back
to normal the module is brought back to the previous state, before RF
RX and TX disabled.
4 - the output pin <GPIO> is tied HIGH when operating temperature
bounds are reached; when the temperature is back to normal the output
pin <GPIO> is tied LOW. If this <action> is required, it is mandatory to
set the <GPIO> parameter too.
<hyst_time> - hysteresis time: all the actions happen only if the extreme or
operating bounds are maintained at least for this period. This
parameter is needed and required if <action> is not zero.
0..255 - time in seconds
<GPIO> - GPIO number. valid range is “any output pin” (see “Hardware User’s
Guide”). This parameter is needed and required only if <action>=4 is
required.
Note: the URC presentation mode <urcmode> is related to the current AT instance
only (see +cmux); last <urcmode> settings are saved for every instance as
extended profile parameters, thus it is possible to restore them either if the
multiplexer control channel is released and set up, back and forth.
Note: in case that action 4 is set, the chosen GPIO has to be configured in alternate
function ALT3 through AT#GPIO command
Note: last <action>, <hyst_time> and <GPIO> settings are saved in NVM too,
but they are not related to the current CMUX instance only (see +cmux).
Read command reports the current parameter settings for #TEMPMON command
in the format:
To Next Page
Loading...
