Telit Wireless Solutions LE910 User Manual

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 134 of 509
Mod. 0808 2011-07 Rev.2
+CGCONTRDP - PDP Context Read Dynamic Parameters
sec_addr>]]]]]]
[…]]
Description
The execution command returns the relevant information <bearer_id>,
<apn>, <ip_addr>, <subnet_mask>,
<gw_addr>, <DNS_prim_addr>, <DNS_sec_addr>, <P-CSCF_prim_addr>
and <P-CSCF_sec_addr> for a non- secondary PDP Context established by
the network with the primary context identifier <p_cid>. If the context
cannot be found an ERROR response is returned.
If the parameter <p_cid> is omitted, the relevant information for all
established PDP contexts are returned.
NOTE: The dynamic part of the PDP context will only exist if established by
the network.
The test command returns a list of <p_cid>s associated with active
contexts.
NOTE:
If the MT has dual stack capabilities, two lines of information are
returned per <cid>. First one
line with the IPv4 parameters followed by one line with the IPv6
parameters
Defined values
<p_cid>:
a numeric parameter which specifies a particular non secondary
PDP context definition. The parameter
is local to the TE-MT interface and is used in other PDP context-related
commands.
<bearer_id>:
a numeric parameter which identifies the bearer, EPS
Bearer in EPS and NSAPI in UMTS/GPRS.
<APN>:
a string parameter which is a logical name that was used to select
the GGSN or the external packet data
network.
<ip_addr>:
a string parameter which shows the IP Address of the MT. The
string is given as dot-separated
numeric (0-255) parameters on the form:
"a1.a2.a3.a4" for IPv4 or
"a1.a2.a3.a4.a5.a6.a7.a8.a9.a10.a11.a12.a13.a14.a15.a16" for IPv6.
<subnet_mask>:
a string parameter which shows the subnet mask for the
IP Address of the MT. The string is
given as dot-separated numeric (0-255) parameters.
<gw_addr>:
a string parameter which shows the Gateway Address of the
MT. The string is given as dot-separated

Telit Wireless Solutions LE910 Specifications

General

Brand	Telit Wireless Solutions
Model	LE910
Category	Control Unit
Language	English