Telit Wireless Solutions LE910 - Page 212

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 212 of 509
Mod. 0808 2011-07 Rev.2
#MONI - Cell Monitor
SELINT 2
0 – it is the serving cell
1 – it is the intra-frequency cells
2 – it is the inter-frequency cells
3 – it is the WCDMA neighbour cells
4 – it is the GSM neighbour cells
5..7 – it is not available
Execution command (AT#MONI<CR>) reports GSM/UMTS-related information
for selected cell and dedicated channel (if exists).
1. If the last setting done by #MONI is in the range [0..6], the output format is as
follows:
a) When extracting data for the serving cell and the network name is known the
format is:
(GSM network)
#MONI: <netname> BSIC:<bsic> RxQual:<qual> LAC:<lac> Id:<id>
ARFCN:<arfcn> PWR:<dBm> dBm TA: <timadv>
(UMTS network)
#MONI: <netname> PSC:<psc> RSCP:<rscp> LAC:<lac>
Id:<id>EcIo:<ecio> UARFCN:<uarfcn> PWR:<dBm> dBm DRX:<drx>
SCR:<scr>
(LTE network)
#MONI: <netmame> RSRP:<rsrp> RSRQ:<rsrq> TAC:<tac> Id:<id>
EARFCN:<earfcn> PWR:<dBm> DRX:<drx>
b) When the network name is unknown, the format is:
(GSM network)
#MONI: <cc> <nc> BSIC:<bsic> RxQual:<qual> LAC:<lac> Id:<id>
ARFCN:<arfcn> PWR:<dBm> dBm TA: <timadv>
(UMTS network)
#MONI: <cc> <nc> PSC:<psc> RSCP:<rscp> LAC:,<lac> Id:<id>
EcIo:<ecio> UARFCN:<uarfcn> PWR:<dBm> dBm DRX:<drx>SCR:<scr>
(LTE network)
#MONI: Cc:<cc> Nc:<nc> RSRP:<rsrp> RSRQ:<rsrq> TAC:<tac>
Id:<id> EARFCN:<earfcn> PWR:<dBm> DRX:<drx>
c) When extracting data for an adjacent cell (or active set cell), the format is:
(GSM network)
#MONI: Adj Cell<n> [LAC:<lac> Id:<id>] ARFCN:<arfcn>
PWR:<dBm> dBm
(UMTS network)
#MONI: PSC:<psc> RSCP:<rscp> EcIo:<ecio> UARFCN:<uarfcn>
SCR:<scr>
(LTE network)
(LTE intra-frequency and inter-frequency cells)