Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 213 of 509
Mod. 0808 2011-07 Rev.2
#MONI: RSRP:<rsrp> RSRQ:<rsrq> Id:<id> EARFCN:<earfcn>
PWR:<dBm>
(LTE WCDMA neighbour cells)
#MONI:
PSC:<psc
> RSCP:
<rscp> EcI
o:<eci
o> UARFCN:<u
arfcn>
SCR:<scr>
(LTE GSM neighbour cells)
#MONI:
Adj Cell<n
> BSIC:<b
sic
> ARFCN:<arf
cn> PWR:
<dBm>
where:
<netname> - name of network operator
<cc> - country code
<nc> - network operator code
<n> - progressive number of adjacent cell
<bsic> - base station identification code
<qual> - quality of reception
0..7
<lac> - localization area code
<id> - cell identifier
<arfcn> - assigned radio channel
<dBm> - received signal strength in dBm; for serving cell in UMTS network
this is not available during a call, and is displayed as 0
<timadv> - timing advance
<psc> - Primary Scrambling Code
<rscp> - Received Signal Code Power in dBm; for serving cell this is not
available during a call, and is displayed as 255
<ecio> - chip energy per total wideband power in dBm; for serving cell this is
not available during a call, and is displayed as 255
<uarfcn> - UMTS assigned radio channel
<drx> - Discontinuous reception cycle length
<scr> - Scrambling code
<rsrp> - Reference Signal Received Power
<rsrq> - Reference Signal Received Quality
<tac> - Tracking Area Code
<earfcn> - E-UTRA Assigned Radio Channel
<ura_id> - UTRAN Registration Area Identity
Note: TA: <timadv> is reported only for the serving cell.
2. If the last setting done by #MONI is 7, the execution command produces a
table-like formatted output, as follows:
(GSM network)
a. First row reports the identifying name of the ‘columns’
#MONI:
Cell BSIC LAC CellId ARFCN Power C1 C2 TA RxQual PL
To Next Page
Loading...
Need help?
General
