Telit Wireless Solutions LE910 - Page 145

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 145 of 509
Mod. 0808 2011-07 Rev.2
0 (default value)
10…4000
<Traffic handling priority >
- Traffic handling priority
1…3
<Source Statistics Descriptor>
- Characteristics of the source of
the submitted SDUs for a PDP context. This parameter should be
provided if the
<Traffic class>
is specified as conversational or
streaming.
0 - Characteristics of SDUs is unknown (default value)
1 - Characteristics of SDUs corresponds to a speech source
<Signalling Indication>
- Signalling content of submitted SDUs for
a PDP context. This parameter should be provided if the
<Traffic
class>
is specified as interactive.
0 - PDP context is not optimized for signalling (default value)
1 - PDP context is optimized for signalling.
Note: a special form of the Set command,
+CGEQMIN=<cid>
causes the requested profile for context number
<cid>
to become
undefined.
Note: the current settings are stored in NVM.
Note: set command can modify the 2G QoS according to 3GPP
23.107 (see +CGQMIN).
AT+CGEQMIN?
Read command returns the current settings for each defined
context in the format:
[+CGEQMIN: <cid>,<Traffic class>,<Maximum bitrate
UL>,<Maximum bitrate DL>,<Guaranteed bitrate
UL>,<Guaranteed bitrate DL>,<Delivery order>,<Maximum SDU
size>,<SDU error ratio>,<Residual bit error ratio>,<Delivery of
erroneous SDUs>,<Transfer delay>,<Traffic handling>,<Source
statistics descriptor>,<Signalling indication><CR><LF>]
[+CGEQMIN:…]
Parameters are described as for the set command except:
<Traffic class>
- Traffic class
0 –
conversational (if the value is explicitly defined, otherwise, if the
context or the QoS is undefined it is the default value as undefined)